Master-force 241-0303 Manual do Operador descarregar pdf (Página 14)

3. If a different battery pack also indicates “defective,” the charger may be

defective.

BATTERY CHARGING

If the battery pack is being charged within a normal surrounding temperature

range (50 °F to 104°F), the green LED will begin ﬂashing and the red LED will

be off. The battery pack will reach a full charge in 30 minutes.

BATTERY FULL

When the battery is fully charged, the green LED Light on the charger will

illuminate and the red LED light will be off.

NOTE: The battery pack will fully charge, but will not overcharge, if left on the

charger.

NOTE: Charger may warm with several continuous charge cycles. This is part

of the normal operation of the charge. Charge in a well ventilated area.

TO ATTACH BATTERY PACK (Fig. 4)

1. Lock the trigger switch on the

Impact Driver by placing the

direction of rotation (forward/

center lock/reverse ) selector in

center (OFF) position.

2. Align the raised rib on the battery

pack with the grooves of the Driver,

and then attach the battery pack to

the Impact Driver.

CAUTION! When placing the battery pack in the tool, be sure that the raised

rib on battery pack aligns with the groove inside the Impact Driver and that the

latches snap into place properly. Improper attachment of the battery pack can

cause damage to internal components.

TO DETACH BATTERY PACK (Fig. 4)

1. Lock the trigger switch on the Impact Driver by placing the direction of

rotation (forward/center lock/reverse ) selector in center position.

2. Depress the battery release buttons located on the both sides of the

battery pack to release the battery pack.

3. Pull the battery pack out and remove it from the tool.

WARNING! Battery tools are always in operating condition. Therefore, the

direction-of-rotation selector should always be locked when not in use or car-

rying at your side.

Attach

Detach

Fig. 4

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Sem comentários

Master-force 241-0303 Manual do Operador Página 14