Master-force 252-8020 Manual do Operador descarregar pdf (Página 10)

Page 9

ROTATING/CHANGING

THE CUTTERS

WARNING:

To avoid serious

personal injury, always remove the battery

pack from the tool before undertaking any

assembly, adjustments or cutter changes.

The upper and lower cutters are identical;

each has four cutting edges. The cutters can

be interchanged or rotated.

When the cutting performance is unsatis-

factory, rotate each cutter 90°or replace it.

To rotate a cutter, loosen the attachment

screw of the cutter, rotate the cutter 90°and

tighten the screw.

To replace the cutter, remove the attachment

screw from the cutter, remove the old cutter,

position the new cutter as shown inprovided

(Fig. 1). thread the screw into the cutter and

securely tighten the screw with the 3mm hex

wrench provided.

WARNING:

Ensure that the lower

cutter rests against the adjustment screw.

ADJUSTING THE CUTTER

CLEARANCE

WARNING:

To avoid serious

personal injury, always remove the battery

pack from the tool before undertaking any

assembly, adjustments or cutter changes.

The cutter clearance “a” (Fig. 2) has been

adjusted at the factory to 0.004” and, under

normal use, does not need to be adjusted.

ASSEMBLY

WARNING:

If any part is broken

or missing, DO NOT attempt to attach the

battery, plug in the power cord or operate

the tool until the broken or missing part is

replaced. Failure to do so could result in

possible serious injury.

WARNING:

Do not attempt to

modify this tool or create accessories not

recommended for use with this tool. Any

such alteration or modiﬁcation is misuse

and could result in a hazardous condition

leading to possible serious injury.

WARNING:

Your tool should

never be connected to the power source

when you are assembling parts, making

adjustments, cleaning, or when it is not in

use. Disconnecting the tool will prevent

accidental starting, which could cause

serious personal injury.

CONTENTS

Cordless metal shear, 12V battery pack

2pcs, charger, cutter gauge, 2mm hex

wrench, 3mm hex wrench, soft bag and

instruction manual.

UNPACKING

1. This product has been shipped

completely assembled.

2. Carefully remove the tool and any

accessories from the box. Make sure

that all items listed in the packing list

are included.

3. Inspect the tool carefully to make sure

that no breakage or damage occurred

during shipping.

4. Do not discard the packing material

until you have carefully inspected and

satisfactorily operated the tool.

a

FIG. 2

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Comentários a estes Manuais

Sem comentários