Master-force 252-8020 Manual do Operador descarregar pdf (Página 14)

Page 13

OPERATION

1. Before cutting, lightly oil the cutting

line with cutting oil; do not use any

ﬂammable materials

2. Hold the tool at a forward-tilting angle of

80° to 90° to the workpiece; do not tilt

the tool side to side.

3. Turn the tool on. Your tool should be

running at full speed before starting

the cut.

4. Guide the tool evenly with light

feed pressure in the direction cut.

Excessive feed pressure will reduce

the performance considerably, shorten

the life of the cutters and can cause

damage the tool.

5. When cutting curves, work with a light

feed pressure and do not tilt the tool

laterally.

6. Turn off the tool only after completing

the cut.

Sharp cutters produce good cutting results

and protects the tool.

WARNING:

Do not load the tool so

heavily that it stalls.

CAUTION:

When placing the

battery pack in the tool, be sure that the

raised rib on battery pack aligns with

the groove on the metal shear and the

latches snap into place properly. Improper

assembly of the battery pack can cause

damage to internal components.

HOW TO CUT METAL SHEET

(FIG.5)

WARNING:

Do not use the shears

without the hand guard securely in place.

80-90°

FIG. 5

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Comentários a estes Manuais

Sem comentários